Rear quarter body help needed

[

If you have to go back over your work to fake your method of repair so it looks like another method of repair, you're a dishonest hack. Doesn't matter if you've been doing
If you need the finished work to look a certain way, you use the method of repair that results in that look. Plain and simple. Need your spot welds to look like they were done with an induction welder? Use an induction welder! How hard is that? Don't spend twice as much time faking your MIG welds to look like they were done with an induction welder. No amount of trickery and BS will change the fact you actually did them with a MIG, regardless of how good you are at faking the way that they look. If it's that important that they look right, do the work right. Don't take a shortcut and then lie about it.


The problem with this philosophy is that some areas will be inaccessible for a squeeze type resistance spot welder. Some alternate method (MIG, TIG) will have to be used. If duplicating the factory look is desired, some amount of "fakery" will be required.