massive reconfiguration time again.

Since I kind of have the front together I was able to give that new front bumper a test fit and was extremely pleased. I had some conversations I can't remember which which company last year when I was considering all this. I tested the rear bumper that I got at a swap meet and it seemed like a replica of the stock bumper. Meaning when I tucked it up close the ends would stick out way too far. So I've already resolved the fact that I'm going to have to cut it in two places and bring it in. I can't cut it in the middle or else it would make a 6in wide license plate openings. I remember calling and asking if this could be corrected at the factory and wasn't able to get a satisfactory answer. But it seems as if this front bumper has been corrected. When I put it up against the front it didn't seem to stick way out too far out on the sides like the back does.