Firewall/Engine Bay Smoothing

Thanks guys! Most of the holes on the firewall I'm filling are where the push plugs go on the inside to hold the original firewall insulation. I'm going to use Dynamat or the like so I don't need those. I'm also getting rid of the big factory bulkhead connector. I'll use an aircraft style bulkhead connector instead, relocated.

I'm also wanting to run all the headlight wires inside the fender so I can eliminate the holes for the wire bundle clips on the inner fender. This should let me fill the ~1.5" hole (where the circular body plug is) that the headlight wiring enters through.