uca bolts

72bluNblu said
Did you grease the UCA cam bolts when you installed them? And are they torqued to spec?

There was an issue with one of the new cam bolt manufacturers not cutting the flats deep enough awhile back, the eccentric washer would bottom out before the bolt was putting enough clamp pressure on the UCA mount. If you have new UCA bolts it’s worth checking.
Click to expand...
no grease on the bolts,the eccentric are oem,as for torqued there very tight,as said the right side was doing the same thing,tighten them up as tight as i can with out my torqued wrench noise gone but STILL there on the left side. i have done a few front end rebuild in the past never had this problem.thanks 72bluNblu.