United Car Tool Torque boxes - can they go in AFTER subframe connectors?

According to you, you made your own sub frame connectors. So, what is your point 72blunblu?
Once again your trying to claim to be an expert at something you haven't done. But, you'll follow this right up with another post to inflate your ego over trying to be right. But now you will tell everyone that you used them?

I've put their product on 3 Mopar cars now.

I notice in the picture you posted the sub frame connector is hammered flat for about 3"-4" to make it hit where it should. You can go the caveman route, which will take the bend radius out of the connector, which causes cracks, looks like hell...

And my subframe connectors fit just about perfect out of the box. But, here you go with you're wisdom over something you have posted over and over to not have done or used. If you look at US Car Tool's old original design when they didn't pre-bend the subframe connectors it will become clear what they knew about the floor pan angle.

LOL