Well, look what we have here!

Bobzilla said

I'm curious to see the real flow numbers instead of their advertised numbers, but I understand that everybody gets different numbers on different benches so I'd really like to see a side by comparison with a well ported Edelbrock RPM head and onw of the Trick Flow heads on the same bench and the day, with same guy running the test.
Also, can't wIt to see some builds with stock stroke and bigger strokers.
I'm starting to save pennies to get a set when I can.

Click to expand...

At the end if the day this head is going to be way to small for a 4 inch crank motor, just like an eddie is. I had a pretty cookie cutter 10.70ish 3350 pound flat tappet eddie motor and it weezed looking for the stripe about 150 feet out.
Even W2/W5 stuff is barely adequate.
I dont want to get a license again and all that entails, so i look at these heads as probably really nice castings that i can get to run in the bottom 10’s with and expect to be trouble free doing so.