Anyone else using MegaSquirt on a LA motor?

Some generalities: The lean burn is NOT phased pickup to rotor. You will have to adjust the MS electronics to phase it. Not sure on that procedure

You must properly shield and route delicate low signal pickup cables. What you want to do is find out what the signal ground is at the cable end, and use a two wire shielded cable, grounding the shield ONLY at the MS end. The ground must "float" insulated at the distrib. or other pickup end

Route all low signal/ trigger wires close to a "ground plane" such as the firewall or other ground, and keep them away from high tension or high current wires. Don't run them parallel to those wires/ cables, and try to "cross" them at close to a right angle.

If you have not found him Matt Cramer is very helpful and very involved with MS, and is a member on here as well as the various MS forums.

I am building an MS2 kit for experimentation (if I live long enough) but don't have working knowledge on setting it up. Obviously there are many variables with MS