EFI Conversion

Coyote Jack said
My white wire goes to the tach output wire from my MSD 6AL. I have electric fans but I don't have the FiTech controlling them so I can't help you there.

I kept my setup as simple as I could. No fan control or timing control. My timing is being controlled by the MSD setup very well so I didn't want to mess with it.

Jack

Thank you for the pointers. Which wiring figure did you follow? I am going with Figure 11. I think it is the closest to my current set up. Like you mentioned, I also have a MSD 6AL (but an older one - 6420).

Upon looking at the diagram, (if this is the way to go) it shows the blue wire connects to 'tach out'. Would putting this and the white wire you suggested together work?

I haven't started to run any as of yet, I want to be 110% certain before I start playing around