An easy way to install your twin scoops. NO TEMPLATE

str12-340 said

1994redram (And all others) I'm interested in how you were able to use the hole saw for the air inlet without distorting the hood, or if anybody else has another method. I keep thinking that someone must make a device the would shear the hole out like they must have done at the factory without any heat produced.

Click to expand...

Just go slow. You don’t need to ram the hole saw through in a few seconds, get it centered up and then just cut at a low rpm. You can even use some cutting fluid if you want. Worked fine when I did mine, very little heat and no distortion. Just take your time.

The template I used worked great too. Sure, you don’t need one, but as long as you check the template against the 4 holes in the hood bracing you won’t put the holes in the wrong spot and the template speeds up the whole process.