67 Barracuda, which wiper and switch do I have?

Frnknsteen said

I did a quick search and none of the 2spd switches I saw had the resister on it. On the pictures I saw, the only ones with resisters were the 3spd switches.

Click the switch through its ranges to see how many positions there are. If there are 3 positions, it should be a 2 spd (off, Low, and High). If it has 4 positions, it should be a 3spd switch (Off, Low, Middle, & High).

Click to expand...

I did that and it clicks like a 2 speed. Off, click 1, click 2.
I see the same as you, I see the typical 2 speed switches with no resistor built into them. The connector under the dash seems original to and my resistor switch connects correctly.
I looked on this forum about how to test the motor. I would think just putting 12 volts to it, and make sure it has ground and it should spin if it works. I probably need to pull it out and wire it up with the switch though, and just make it work there them re-install it.