Edelbrock Rpm heads on 360
I have a sweet wee 360 with 30thou hyperutechnic pistons, balanced and running 4 speed 833 O/D with dodge 8 1/4 3.9 LSD. Its in a rough old 1971 Valiant ute.
Have done about 1000miles in it and it went well with steel J heads 1.9intakes,
Have just purchased some edelbrock RPM heads to go on it.
Heads have been checked over and reassembled and the springs to suit cam installed.
Planning on using factory rocker gear off the J heads.
My question is will my rockers and pushrods fit the new heads?
Have a head stud kit and felpro gaskets but looks like I need some 1008s.
Anything else I should be aware of before I install them?
I have a sweet wee 360 with 30thou hyperutechnic pistons, balanced and running 4 speed 833 O/D with dodge 8 1/4 3.9 LSD. Its in a rough old 1971 Valiant ute.
Have done about 1000miles in it and it went well with steel J heads 1.9intakes,
Have just purchased some edelbrock RPM heads to go on it.
Heads have been checked over and reassembled and the springs to suit cam installed.
Planning on using factory rocker gear off the J heads.
My question is will my rockers and pushrods fit the new heads?
Have a head stud kit and felpro gaskets but looks like I need some 1008s.
Anything else I should be aware of before I install them?
