Heres off the intructions on summit
“Install the hood pin plates. Note that the plates will be attached with tape, so if the hood has been recently waxed you may want to remove the wax around the hood pins so the tape will stick. Tape the recessed bottom surface of each hood pin plate. Cover the entire surface so the tape laps over the sides and then trim the tape inside the recess flange and around the center hole. Close the hood and remove the protective plastic from the double sided tape. Center each plate on the hood pin and lower it to contact the hood. Press them into place.”
They probably dont advertise it cause $200 for tape on hood plates is a rip off! Thats what your relying on to mate up with the pin in cause of a hood latch failure
