Moog LCA Bushings

Oh, and by the way, the way the rubber is bonded to the new bushing and shell, it laps over the top of the shell where it used to be bare metal. That caused the pipe that I use for a mandrel to install the bushing into the CA to "squirm" under pressure...very difficult to keep the mandrel straight up/down and get a good centered press.

One method that i tried, and seemed to work well for me is, i have a bench grinder with a 6 inch wire wheel brush on one end of it.
I wire wheeled away that excess lip of rubber on the bushing to keep the pressing in "driver" from moving around the top lip of the bushing.
Seemed to work well for me, so I'd do it again, in the future, if i had to use the new style, manufactured, bushings.