Rocker geometry pics-look good?

mbaird said
I will take your advice and order 12 of each. Hopefully I never need them.
I plan on going with 5/16 hardened , Oil thru Ball and cup. Smith Bros catalog says they are good for up to 700# spring pressure. I am at #600 so they should work fine.

Can you get a 3/8 .120 wall? You can't get a pushrod stiff enough. I run bigger pushrods than that on my SFT stuff.

I've never bought into the spring pressure idea to pick a pushrod. IMO, you stuff the biggest, heaviest pushrod in there you can fit.

I was running 3/8-7/16 double taper pushrods on my stuff, and it was on the edge of not being stiff enough at times.