742 case setup help
I have been trying to set this up myself. Right now I have the stock shim under the big bearing no shim on the small bearing just snugged the nut for some bearing preload for gear mesh purposes. I have about .007 backlash at 3 spots.
I attached some pics for the pattern. Is it acceptable?
The gears are brand new Richmond 4:10's. All new timken bearings.
I have been trying to set this up myself. Right now I have the stock shim under the big bearing no shim on the small bearing just snugged the nut for some bearing preload for gear mesh purposes. I have about .007 backlash at 3 spots.
I attached some pics for the pattern. Is it acceptable?
The gears are brand new Richmond 4:10's. All new timken bearings.