[SOLD] Parking Brake Levers & Struts For The 11" Inch Rear Brakes.

-
Status
Not open for further replies.

hemi71x

FABO Gold Member
FABO Gold Member
Joined
Dec 22, 2009
Messages
7,617
Reaction score
4,850
Location
Rancho Cordova, CA
Rating - 100%
73   0   1
Contact seller
These are a set of parking brake levers and struts for 11 inch rear Drum Brakes, that are used on cars, trucks, vans, during the mid, and later 1970's, and well into the 1980's, and 1990's.

The levers are the "hook type" design that install into a little slot in the brake shoe itself.

Can be used on any 1960's and 1970's vehicle by just using the later brake shoes.

These parts were just removed from a 79 St. Regis ex cop car, donor vehicle, so i am fully aware what they came off of, and what they fit.

Levers & struts can be used on any 2", 2 1/2", 3", width brake shoes.

$40.00 for the parts, $7.25 for the mailman $1.75 Pay Pal
$49.00 Total, into my account.

Send me a pm, and i will send you my e mail address, for payment.

Thank's a lot.
Jim V.

Parking Brake Levers & Strurs 001 (Small).JPG


Parking Brake Levers & Strurs 002 (Small).JPG


Parking Brake Levers & Strurs 003 (Small).JPG
 
There is a differant style parking brake levers other than hook?

I see theres a pin style as well since u deal with alot of this are the backing plates the same for pin and hook style parking brake??

So my question is would the backing plates off a e body and a c body be the same?

If there all the same I'll take these
 
Last edited by a moderator:
Status
Not open for further replies.
-
Back
Top