Machining recommendations 440

I used to live in Post Falls. Had the 426 in my '65 Coronet redone by Pat at Pat's Trans Doc back in the day. He was the big Mopar guy in the area back then, had a whole fleet of Hemi cars including some factory race Hemi stuff. No idea where to go these days but I'm sure there are some good shops in the area. Lots of motorheads up there.

Do you have a copy of my big block book? The book should answer most of your questions. You can get it at Amazon.
https://www.amazon.com/dp/1613250924/?tag=joeychgo-20

Yes I do have a copy. I am only up to valvetrain in my reading. Thanks for replying. I think pat did my t5 for my 1950 Chevy 10 years ago. Your book is a great reference manual

image.jpg