Underdash Harness Help

-

Calipag

Well-Known Member
Joined
Apr 11, 2018
Messages
446
Reaction score
275
Location
Corona California
I've pulled my dash harness and I have labeled just about everything. I am unable to figure out from the diagram from mymopar.com all but these connections. The last photo of the light green wires are from the driverside kick panel and I'm guessing are for the door switch but the diagram shows them in yellow. The passenger side wires are yellow and ring out to the connector (photo #3) that has the yellow wire to it, that I can't identify.

Also, I only have one light bulb for my gauge cluster is that correct?

Thank you for all the help, this build gets deeper and deeper!

IMG_5047.JPG


IMG_5048.JPG


IMG_5049.JPG


IMG_5050.JPG


IMG_5051.JPG


IMG_5052.JPG
 
I believe black connector with all the yellow wires goes to ‘Accessories Lamp wiring’. Would have gone to something like a map light switch. While it was in your harness it’s possible it was never connected to anything.
 
I’m not spotting the black bullet connector with yellow wires right off hand. Seem to recall this one not being connected either but could be wrong. Probably related to accessory lighting though.

Edit: FWIW, I’m going with map and ignition lamp connector. (My Mopar 70 Dart and Challenger Full Diagram, Page 11 or 13 - but for Challenger). Again, bet it wasn’t used on your car.
 
Last edited:
I'm still trying to figure out those light green wires with the black connector out? It was over by the High Beam switch, and the connector to the back of the car.
 
Sadly, I JUST realized I did not label the red and black wires that came off the back of my gauge cluster and I did not label the cluster! Now I'm not sure which posts they went to. I'M SUCH A DUMB ***!
 
I think the circuit board on the back of the cluster has a plus + where the red wire goes.
 
Ok, it is labeled red, so that is where red one goes, the black wire goes on the other real nut, the one about an inch away, up and to the right on the picture. not one of the tin nuts. Is that what you were wanting to know?
 
Ok, it is labeled red, so that is where red one goes, the black wire goes on the other real nut, the one about an inch away, up and to the right on the picture. not one of the tin nuts. Is that what you were wanting to know?
Thank you! When I got home and looked at the gauge I noticed that it said "RED" .
 
-
Back
Top