Another straggler followed me home!
Thank you very much. I swear with patience, almost anyone can do this stuff. Key word is Patience!
The long task begins! I trimmed the quarter close to where it would be cut at. Then I clamped the patch on. I use a 3/64 zip disc to cut. It gives a nice gap to weld. Then I just cut a foot or so, tack a couple spots and carry on. I used the tape for a guide. I cut about 1/4" below the body line. In the end you get a strip from the inside and one from the outside. I'll keep the marker light opening for future use.
Thank you very much. I swear with patience, almost anyone can do this stuff. Key word is Patience!
The long task begins! I trimmed the quarter close to where it would be cut at. Then I clamped the patch on. I use a 3/64 zip disc to cut. It gives a nice gap to weld. Then I just cut a foot or so, tack a couple spots and carry on. I used the tape for a guide. I cut about 1/4" below the body line. In the end you get a strip from the inside and one from the outside. I'll keep the marker light opening for future use.