67/68/69 cuda dilemma
I whittled a little more off the VSS mount pad to make it appear a bit better. I think i'm done with that now. Wire wheeled the **** out of the top half of the 3rd member and primered it.
Got to get this 8.8 apart to do the axle shortening thing. First things first though, its got 1/4" of dried crust on the bottom probably very slow leaking from the diff cover. I employed some paper, an oil catch pan, and some easy off heavy duty oven cleaner. I let it soak about 30 mins before starting to scrape the crust off. Rinsed it all with a squirt bottle and warm water. Want everything clean before i pull the cover. Dont want **** falling inside.
Will go medieval on the bottom of the 3rd member with the wire wheel and then shot can it with rustoleum before i pull it apart.
Stay tuned, i am going to figure out a pinion snubber for this thing too.
I whittled a little more off the VSS mount pad to make it appear a bit better. I think i'm done with that now. Wire wheeled the **** out of the top half of the 3rd member and primered it.
Got to get this 8.8 apart to do the axle shortening thing. First things first though, its got 1/4" of dried crust on the bottom probably very slow leaking from the diff cover. I employed some paper, an oil catch pan, and some easy off heavy duty oven cleaner. I let it soak about 30 mins before starting to scrape the crust off. Rinsed it all with a squirt bottle and warm water. Want everything clean before i pull the cover. Dont want **** falling inside.
Will go medieval on the bottom of the 3rd member with the wire wheel and then shot can it with rustoleum before i pull it apart.
Stay tuned, i am going to figure out a pinion snubber for this thing too.
