Back glass install frustration

DrCharles said

Is anyone actually reading my posts? :( I DID all those things, and it DIDN'T work, in ONE CORNER. :BangHead:

The question is, should I take the time/effort to try and "pick" the gasket in that corner, or remove it and start all over again? Which is less likely to result in a damaged gasket (or worse, broken glass)?

Click to expand...

yes, I did read...
It sounds like you pulled the rope from top down. I'm saying you need to start pulling from bottom center. If you already did that; everything else sounds right.
If you try picking at it be sure you have no sharp edges. I roughed up a corner on my front gasket with a edge on a plastic trim tool. After that I sanded them smooth. But, you said you can't see the corner. So, not seeing that as a likely success. I would most likely pull it and start over.
That glass is actually pretty tough with one exception. If you hit an edge too hard it will disintegrate in a million pieces. Been there, done that.
Good luck!