Fuel Sender Rebuild
I first put solder on the back of the board and then the copper bar. while the bar was still hot I placed the board on and heated them till they pressed together. Once cooled off I did the wiggle test.
That assembly was put back in the frame and tested again, once again mixed results. I then noticed the the float arm had a little play in it causing the pointer to lift off the board. I bent the pointer so it would stay in contact with the board even with the play in the float arm.
Once again everything was tested and this time it all works as it should, next up to put it on the car.
There were multiple things that I saw that could have caused these not to work.
1. Filthy
2. The pointer not staying in contact with the board.
3. The board getting disconnected from the bar.
Alan
I first put solder on the back of the board and then the copper bar. while the bar was still hot I placed the board on and heated them till they pressed together. Once cooled off I did the wiggle test.
That assembly was put back in the frame and tested again, once again mixed results. I then noticed the the float arm had a little play in it causing the pointer to lift off the board. I bent the pointer so it would stay in contact with the board even with the play in the float arm.
Once again everything was tested and this time it all works as it should, next up to put it on the car.
There were multiple things that I saw that could have caused these not to work.
1. Filthy
2. The pointer not staying in contact with the board.
3. The board getting disconnected from the bar.
Alan
