Carpet install

Not sure if I am doing this correctly but here goes... I purchased some ACC carpet and am not all that enamored with it. much of the jute padding is bunched up an adhesived that way. The rear wasn't too bad of an install as I only glued where the jute slips into the floor pan for the most part. Now to the front... A bit of a b*tch to fit. I have a console and did a pretty good job of centering and initiating the cut but according to the jute location it seems there was quite a bit extra material up front. I don't mind the sides as it's easy to get to but the front runs into all the pedals, ducts, wash pump and dimmer switch. I took the dimmer and pump out but it was still a bear to fit because you can't pull it in place while you're laying on it and you have to lay on it the reach and fight the forward end. All that said, I've trimmed the forward end about 2 inches or so and I'm pretty close but was wondering if the dimmer switch should mount above the final install or under with a hole cut for it, which I think would suck. Also, with the jute located where I feel it is best and the heel pad also. the cut outs in the jute for the pump and dimmer (I believe) are off by a couple of inches. If I move it up that far the heel pad will be turning upward. I apologize for the unnecessary info and appreciate any help given...