finaly got something done..

Allright i got alitle something done today,seems hard to be able to find a shop that wants to do do the floor and rockers but i will get there at some point.

So today i took some time looking over some engine parts,CCd the heads or in reality measured the chambers that had the best exhaust valveseats and found them to be 70cc. didnt bother to measure the chambers with sunk valves, picked one of the worse exhaustvalves and tried to get it out,didnt want to let go of the locks and keepers but could tell with both springs on that valve compressed that doing something about the guides is going to be needed. didnt even bother to measure how much the valves move around.
Noticed a variance of about 0.050" in valveseat height by measuring the height difference betwen intake and exhaustvalve in each chamber.
I will most certainly try to find a replacement for those heads.

Also put some time into starting to check the deckheights before deciding on pistons and or rotating assembly
#1 piston is 0.63mm (0.025") over the deck.This is an expected height.
#2 may be 0.365mm (0.014") over the deck but i was in a rush and something did not seem right about how the dial ran over the face,so i will go back and remeasure tomorow,im guessing i might have failed to tighten up one of the links.
Will then measure #7 and 8# aswell.
Decks should be square but not necesarily equal side to side this is due to me being an idiot when i had the block decked but hoping they are equal.

When im done measuring pistons over the deck i will take those pistons out of the block and measure the pistons aswell,tolerances may stack up here, i hope the decks are both a usable equal height and ready for some of the shelf pistons but we will see,no dissaster if they are not i will just become a better friend with the machineshop.