Mid plate mounting

hangn0ut said
Flex plate spacer I use is made to accept the pilot,same as the crank. Never bent anything or had any other problems.

Matts440 said
Like to see those running one how they mounted yours. I ordered one from Chris Alston a steel one with mounts and the plate barely touches the rails on both side.

I am doing this on my 68 dart right now. I am using the comp engineering kit. The plate is .090 thick. It uses a spacer behind the flex plate maintain proper converter position. The one thing I did different and the instructions did not specify but I felt with the mini denso starter that I was loosing too much snout engagement into the trans case so I cut that section out to maintain full engagement like stock.