Mopar electronic ignition wiring schematic question

67Dart273 said
This is from MyMOpar. It is correct except it does not show the bypass (IGN2) circuit which is unchanged, anyhow. Notice at top right it says "splice" and "new wire". This is spliced into the existing ballast power supply wire from the key. So basically you leave the ballast / coil alone, disconnect the points, and hook the wire from the ECU up to the coil NEG in it's place

View attachment 1715251276

Our biggest stumbling block is that we are starting with an empty shell.

So I had no previous hook ups to reference from.