66 Dart Gauge Cluster
here is my list so far.
1. kick panels with speakers in em (check)
2. side panel top trim for the convertibles (almost check, darn plastic was too thin)
3. molded glovebox for 63-66 darts (another darn almost check, since I'm getting webbing and water blisters on the ABS)
4. Armrest pads for the convertibles (again almost done waitin on the metal supplier to get me the formed pieces)
5 Dash pad replacements (I've got the inner core mold mocked up and looking for a great shape Plymouth pad to get the outer shape from)
6. sill plates for the 2 doors. (just in prototype right now for a mold on the computer)
7. wing vent divider cushions for the convertibles and another mold for hardtops (got the convertible ones prototyped but only one of the hard tops)
8. dash cluster revision to round aftermarket guages.
and the list goes on and on and on.
kick panels for 63-66 a bodies (done)
side top trim
convertibles (almost ready)
ahh the pain in the behind one!!! driving me crazy
the glovebox
ahh the armrest pads for the convertible panels
and of course I'm doing the carpet pattern for my dart also
Wing vent divider cushions are molded for the convertible out of shore 80 rubber
and last but not least the dash cliuster as it is and then how I'd like it.
in my project list I have a 66 cluster setup I want to 3d print(then cast it from plastic resin so it's strong.) but it's wayyyyyy down on my list.
here is my list so far.
1. kick panels with speakers in em (check)
2. side panel top trim for the convertibles (almost check, darn plastic was too thin)
3. molded glovebox for 63-66 darts (another darn almost check, since I'm getting webbing and water blisters on the ABS)
4. Armrest pads for the convertibles (again almost done waitin on the metal supplier to get me the formed pieces)
5 Dash pad replacements (I've got the inner core mold mocked up and looking for a great shape Plymouth pad to get the outer shape from)
6. sill plates for the 2 doors. (just in prototype right now for a mold on the computer)
7. wing vent divider cushions for the convertibles and another mold for hardtops (got the convertible ones prototyped but only one of the hard tops)
8. dash cluster revision to round aftermarket guages.
and the list goes on and on and on.
kick panels for 63-66 a bodies (done)
side top trim
convertibles (almost ready)
ahh the pain in the behind one!!! driving me crazy
the glovebox
ahh the armrest pads for the convertible panels
and of course I'm doing the carpet pattern for my dart also
Wing vent divider cushions are molded for the convertible out of shore 80 rubber
and last but not least the dash cliuster as it is and then how I'd like it.