Alternate gas cap location
I welded a panel from a 68 barracuda on my 73 swinger and added a flip top.
Fit well during mock up before paint but it would not sit flush for the final install. Problem was I had to space the fuel tank down about an inch for the aeromotive in tank pump which threw off everything. Solution was to cut 2" out of the filler tube and used a 2"(id) rubber hose to connect them back. Just thought I would mention this for anyone else doing this. Another tip is to use some dialetric grease on the grommet. It makes sliding the tube in a breeze.
Nevermind all the smudges on the chrome. I just finished installing this when the picture was taken. Turned out great I think.
![20181128_195652[1].jpg](https://www.forabodiesonly.com/mopar/attachments/20181128_195652-1-jpg.1715255715/ "20181128_195652[1].jpg")
I welded a panel from a 68 barracuda on my 73 swinger and added a flip top.
Fit well during mock up before paint but it would not sit flush for the final install. Problem was I had to space the fuel tank down about an inch for the aeromotive in tank pump which threw off everything. Solution was to cut 2" out of the filler tube and used a 2"(id) rubber hose to connect them back. Just thought I would mention this for anyone else doing this. Another tip is to use some dialetric grease on the grommet. It makes sliding the tube in a breeze.
Nevermind all the smudges on the chrome. I just finished installing this when the picture was taken. Turned out great I think.
