408 stroker cam recommendations
I just installed a Lunati in a 408 with edelbrock heads to replace the thumper cam that was killing it. It had no vacuum (6 inches) and had to run with 3 1/2 turns of curb idle just to stay running, and forget about idling in gear. If you arent getting crazy with compression (over 10.5) then you could run this cam with either iron heads or edelbrock. It made over 14 inches of vacuum, even with a six pack setup on the 408.
Voodoo Hydraulic Flat Tappet Cam - Chrysler 273-360 268/276 - Lunati Power
I just installed a Lunati in a 408 with edelbrock heads to replace the thumper cam that was killing it. It had no vacuum (6 inches) and had to run with 3 1/2 turns of curb idle just to stay running, and forget about idling in gear. If you arent getting crazy with compression (over 10.5) then you could run this cam with either iron heads or edelbrock. It made over 14 inches of vacuum, even with a six pack setup on the 408.
Voodoo Hydraulic Flat Tappet Cam - Chrysler 273-360 268/276 - Lunati Power
