Post adjustable UCA install - are these correct

I assume you are talking about the adjustment of the heim joints on the UCA mounts?

What was the specs that the alignment was set to? I would think that would tell you if they are where they need to be. If they are both in too far or out too far, Camber would be off. If one is in or out more than it needs to be, Caster would be off.

I would think you would want to adjust them so you have somewhere between 0-1 degree of negative Camber (depending on how you intend to drive it), and have them adjusted properly front to back to have a good amount of positive Caster (2-3 degrees or more).