[FOR SALE] Aluminum SBM Bellhousing

-
Status
Not open for further replies.
jos51700

jos51700

Green Bearing thread connoisseur
Joined
May 24, 2009
Messages
7,386
Reaction score
3,067
Location
Bel-Ray
Rating - 100%
7   0   0
Contact seller
I've had this bellhousing forever. I think it's a truck housing since it has the timing window. Trans pilot hole is 5 1/8" but this DOES NOT FIT Overdrive/A-833. This MAY fit NP435 as mentioned below.

$50 plus actual shipping to you. Trades considered.
Thanks
John
bell.jpg
bell1.jpg
bell2.jpg
 
Last edited:
trns mounting patterns are different . could be redrilled i would think , if there is enough bossing to do threads .
 
jas0162 said:
I could be wrong, but that looks like a NP435 bell. They also had the 5 1/8 hole.
Click to expand...

Welp, you are correct. This does not fit an A-833 as I was told and have assumed for the last fifteen years.

rumblefish360 said:
It does look a bit beefy on the driver side.
Any issue with an older A-833 trans?
Click to expand...

I think you could redrill it but the bosses don't line up with the A-833 very well

As asked in a pm, I cannot find any casting numbers on this bell housing
20181227_223959.jpg
 
Thanks. I’ll have to pass them.
Much appreciated though.
 
Status
Not open for further replies.
-

Back
Top