TTI Rust

I get it, you want nice stuff then take care of it. Other than the scratches on the driver top tube from install, these are close to clean as new.

They also state to spray WD40 where the tubes are welded to the flanges and where tubes are in close proximity because rust can start there and get under the coating, adding:

"These areas are prone to rusting, as the coating is unable to get between the tubes in the unexposed areas of the headers."

At first I thought this made sense, then I thought if you can't coat the entire header, then they are not coated.

Also, if I spray WD40 in these areas how am I expected to clean said WD40 off these seemingly impossible to access areas before starting again?

Ok, I think I'm done ranting now, thank you all.