Sure grip question

69_340_GTS said

So how come when I tried to reassemble the axles with Green bearings the 2nd axle would not go in all the way? Once the buttons were removed, the axles went in all the way. These were stock axles with a Dr. Diff center section. And no, I am not a troll.

Click to expand...

.
With stock bearings and the stock retainer on the right side you have the ability to set the end play on the axles which basically is measured in thousands of an inch.
When you put the green bearings on they are fixed and they allow the axle to go in a little deeper. Therefore they're hitting the block inside the differential. You can adjust this by grinding a little bit off the end of the axle. Or you can simply remove the Block in the center.