Problems installing new pushrods!

#1 pre-oil the motor until oil is pouring over the valve stems . Do this and at the same time rotate motor in the direction of rotation . #2 Bring #1 piston to TDC on the compression stroke . #3 Loosen the adjusters on #1 cylinder . #4 Turn adjuster down while spinning the pushrod with your fingers until you can't spin the pushrod . #5 turn adjuster 1/2 turn more and tighten locknut . Continue this process by rotating the engine clockwise to each firing event . 1-8-4-3-6-5-7-2 . If you are using stock stamped rockers you ovisouly can't do this but you can rotate motor to see if lifters are preloaded . If not preloaded , pre-oil again . Still no go , you have collapsed lifters and they need to be replaced (all of them)