1969 A Body (Barracuda) license bracket
A pic of mine wont help much.
So the top of the bracket bolts to the bumper with 2 nuts and bolts. At the bottom of the bracket are 2 square holes where square plastic nut inserts go. Then the plate is screwed on there. At upper center is a rubber bumper for the plate to rest/bounce against. Your rear license plate is attached the very same way. If you do use the aftermarket plate frame ( I also have those at front and rear plates ) you will probably will need to drill more holes to bolt that frame on. The 2 little plastic nut inserts alone at bottom will not support the aftermarket frames long term. My from frame has a nut and bolt in upper center where the rubber bumper was removed. Yes I had to drill a hole in my frames backplate for this bolt.
A pic of mine wont help much.
So the top of the bracket bolts to the bumper with 2 nuts and bolts. At the bottom of the bracket are 2 square holes where square plastic nut inserts go. Then the plate is screwed on there. At upper center is a rubber bumper for the plate to rest/bounce against. Your rear license plate is attached the very same way. If you do use the aftermarket plate frame ( I also have those at front and rear plates ) you will probably will need to drill more holes to bolt that frame on. The 2 little plastic nut inserts alone at bottom will not support the aftermarket frames long term. My from frame has a nut and bolt in upper center where the rubber bumper was removed. Yes I had to drill a hole in my frames backplate for this bolt.
