Designed to drive HEI module plate...
Let me check as I have both here.
As you can see there are two locating pins on the underside, and both the 4 and 8 pin modules have them.
The 8 pin module mounting screw holes are about 1/4 inch wider apart, so the 8 pin will not fit the D2D plate unless it is re drilled and tapped.
That's IF there is enough material there to do it.
Let me check as I have both here.
As you can see there are two locating pins on the underside, and both the 4 and 8 pin modules have them.
The 8 pin module mounting screw holes are about 1/4 inch wider apart, so the 8 pin will not fit the D2D plate unless it is re drilled and tapped.
That's IF there is enough material there to do it.
