Still stalling after carb rebuild. ???

toolmanmike said
Nice pictures of the bowl vent and linkage but how about the rest of the carb. What is the idle speed set at? Never overlook the obvious or the basics.

Rest of carb pics now up mike. Idle speed screw was screwed all the way in. Again, I’m a novice at carbs, the rebuild went well

69FBCuda said
So she was stalling before the rebuild? Are you sure you have a fuel problem, done all the default troubleshooting? Good fuel pressure? Consistent spark? The running cycle getting progressively shorter as the car warms up? All stock? Set the idle screws at 1 to 1-1/2 and leave. Check the static timing(TDC)

yes, she was stalling before the rebuild after About 3-5 min and sounding rough, after rebuild she sounds much smoother and idles for about 6-8 before stalling. New fuel tank, lines, filter, the filter stays full, I have all three idle screws in same setting they were when I got the car. Pics of them here....idle vent screw (correct me if I’m calling it incorrectly) is all the way in. I did adjust the float to spec when I did rebuild.