How to correct this problem.
Will try a new measurement tomorrow, and torque them to spec. This might be a long shot, but I found a raised imperfection on the bellhousing. This imperfection is closed to eight o clock. Same location of the high calibration reading. Here’s a few pics of it, but they really don’t show it very good. Ran some 400 grit paper on a hard block over this spot to remove it.
Will try a new measurement tomorrow, and torque them to spec. This might be a long shot, but I found a raised imperfection on the bellhousing. This imperfection is closed to eight o clock. Same location of the high calibration reading. Here’s a few pics of it, but they really don’t show it very good. Ran some 400 grit paper on a hard block over this spot to remove it.
