Headers For "A" B-Body W/360

I have owned 2 Magnums. Only a short gap of not owning one between the two cars. 20 years total time with those car(s). Both ‘79’s

I have not tried or seen Dougs or TTI headers on the these cars. I have used twice now Hooker Super Competition headers that are a 1-3/4 tube into a 3 inch collector. I’ll stick with there excellent no issue fit.

The Hookers fit B & E body cars, auto or manual trans except IF you have a Lakewood scatter shield. Hooker will need and TTI suggests cutting the scattersheild to fit the headers. I just dented the inter fearing pipe on my 360 4spd Cuda.

TTI for certain list on there site that there headers fit. IDK about Doug’s.

You’ll hve to price check the headers on how is cheaper. But all three I mentioned are not $89 cheapies. You’ll pay and be very happy you did on the fitment.

The Hookers are a straight 1-3/4 tube smoothly bent. A nice header as far as I’m concerned. There best suited to high HP engines, but, I have used a stock 318 2bbl. In the Magnum and the Hookers without I’ll effect. Even with 2.76 gears, the engine didn’t suffer any noticeable power loss and moved the car no problem.

The TTI headers are stepped headers and normally give a low to mid rpm torque advantage. This may be an attractive item depending on what your doing and what you want.

Also, IMO & if the cost is t to much, step up to a 2-1/2 exhaust pipe size. TTI has a full system from header collector to bumper. With or without the Dyno Max Super Turbo mufflers. True duals, H & X pipes.

I know there expensive but the quality fit will help you forget.

Any of the other header designs are just copies (maybe with a tweak?) of the original crap header design with little QC effort. So fitting one in with a good fit is a dice roll.