[FOR SALE] 73 Duster Bare Body and Built 318

-
Status
Not open for further replies.

Steven Smith

Member
Joined
Feb 21, 2019
Messages
5
Reaction score
7
Location
Tell City, Indiana
Rating - 0%
0   0   0
Contact seller
I have a Duster that has a pretty decent body! I just recently rebuilt the 318. The shop who bored the block estimates it close to 370HP! The guy i bought it from gutted the interior and i was using it for a drag car so never bought anything for it. The car has been sitting in my garage for two years and has yet to be broke in. Looking for $4k. Serious inquires message me!

image1.jpeg


image3.jpeg


image4.jpeg


image5.jpeg


IMG_2627.jpg
 
does it come with seats?
Is the engine hooked up and ready to run?
What has been done to the engine?
Is there a title?
What does it have for a transmission and a converter?
 
Last edited:
does it come with seats?
Is the engine hooked up and ready to run?
What has been done to the engine?
I have the Driver seat but that is it. The engine is sitting in with the transmission mounted however the driveshaft was removed. The car currently has a 7 1/4 rear end which more then likely wont hold up to the new motor. It has been bored 30 over (Forged KB Pistons) and the crank has been balanced. All new Eldebrock RPM top end Kit besides having Comp Cams. Im sure if i call summit i can have them send me all the purchase history. Went with a brand new msd distributor with race ready rotor. I also installed hydraulic lifters. All top end parts are for 360. It also has a eddy Air gap intake. The eddy carb is only a 600cfm currently for the break in stage.
 
How about where is it located?
Also 318 with hydraulic lifters AND 370 hp?!?
 
It is located in Grand Forks, ND right now but im goin to be out of the military in 4 months. At that point it will be in Tell City, Indiana. The engine was built to run 1/8 drag strip. It wont run 7.00 flat but it will move pretty damn good. The cam calls for a 3500 stall torque converter lol
 
Status
Not open for further replies.
-
Back
Top