Rocker arm measurements

Man that is great, thank you. One thing though. And I hate to even ask for more, but if you can measure again from the tip of the valve stem pad to the outside adjuster HOLE on the rocker itself, not the adjuster, that would be the measurement I am lookin for. Also if you can, the width of the rocker shaft hole from one side to the other. I think that will do it. Again, this may all be for naught, but if it's not, we might have a viable alternative for a ductile iron adjustable rocker arm for the slant six.


dartfreak75 said
Ok here is what I got for you. The way I measured the center out measurement was by measuring the center hole I got .880 then subtracting. 440 fro the total because I measured from the outside of the hole. I figured it would be more accurate this way.
I got total length 3.474
Center of hole to the end of pad 2.075
Center to outside of adjusting nut 1.36
If you add the numbers up I'm. .037 off some where If that is not close enough I can remeasure no problem at all. I include some pics just to make sure this is exactly what your asking for. Let me know if you need anything else.

View attachment 1715298965

View attachment 1715298966

View attachment 1715298967

View attachment 1715298968

View attachment 1715298969

View attachment 1715298970

View attachment 1715298972

View attachment 1715298973

View attachment 1715298974

View attachment 1715298975
Click to expand...