Offset ball joint part number?

Look it up in the factory service manual. U can roughly measure ride height from the floor to the bottom of the control arm, off hand I don’t recall what it is supposed to be. Or u can measure from the floor to the wheel lip of the fender. I try to have the passenger side a little higher to compensate for the crown of the road. U can try rotating the caster/camber bolts like this. Rear so the rear of the control arm is all the way in. Front so the front of the control arm is all the way out. See what u got, then adjust from there. A level will get u close. Then adjust toe. Straighten the steering wheel. Then adj so the tires look straight. Take a tape measure, a helper is nice to have here, measure from the Center of the tread at the rear of the tires. Mark the Center where u measured from. Roll the car ahead till the marks are at the front and remeasure. Ur looking for an 1/8 inch toe in. Measure and re measure till u get ur numbers. Make sure u have retightened everything up. Test drive. Now u can take it for a wheel alignment. Kim