Engine Run/Test stand

Local steel shop, box beam in box beam.
I used a chop saw to cut the lengths as needed. Welded them togther. Presto.
Wire it up like a car or use the MP directions for “Widing up a Hot Rod” & you’ll be good to go.
Not seen is a battery tray and fuel cell tray. (Gas can with tube stuck in it under the fuel pump.)

Totally adjustable for what ever sits between the rails. Though I would need to probably make a plate for the transmission bell for what ever other make sits in there.

Harbor Freight 4 inch castors were used since it clears with a couple of plates on top of the castors for the engine hoist to roll under it.