Twin turbo headers and piping
Located in Riverside Ca
Asking $800
Prefer local pick up since it's all so bulky. Went a different route since these headers dont work on r or ritter blocks. They are headman truck headers, set up for gt45 turbos 4" outlet, will need to space engine 1/4" up due to feed tubes from headers to turbos go between mount and block. T4 flanges, 60mm wastegates were ran when Maddart had his engine on the dyno but not since. I took off some of the header wrap on the one side to see where it was hitting, it's all there just need to reattach. Has 02 bungs on both down pipes as well as support brackets to the bell housing. Just need hardware and gaskets for headers and feed pipe. Downpipe is 4" down to 3.5" the rest of the way.
Located in Riverside Ca
Asking $800
Prefer local pick up since it's all so bulky. Went a different route since these headers dont work on r or ritter blocks. They are headman truck headers, set up for gt45 turbos 4" outlet, will need to space engine 1/4" up due to feed tubes from headers to turbos go between mount and block. T4 flanges, 60mm wastegates were ran when Maddart had his engine on the dyno but not since. I took off some of the header wrap on the one side to see where it was hitting, it's all there just need to reattach. Has 02 bungs on both down pipes as well as support brackets to the bell housing. Just need hardware and gaskets for headers and feed pipe. Downpipe is 4" down to 3.5" the rest of the way.
