Location for 3" Tube on Pass Side, 70 Duster

The problem is the header on the pass side is too long to run an "S" curve in the exhaust. What I figured out to do is to cut the header, take out about 3 inches or so. That should give more clearance for the "S" that does need to be there, but right now it would be too sharp, but not only that, the drivers side doesn't have much of a curve at all to meet the cutout/divit/ whatever it is, that the exhaust is supposed to go through. That would make the pressures uneven, by a long shot. It's not that I want to take a short cut, it is too sharp of a curve. It may be less than a foot, not sure, but at the most it's a foot.

I appreciate everyone, thanks!