Basic Header install tips for 1st timers

Great video.

On my 69 barracuda the driver side had to go up about 3 inches. I additionally removed the upper hose at the radiator, drain enough coolant so the fins show inside the tank then pull the hose. Also I removed the distributor cap so not to damage it, this also gets the plug wires out and away. I did have to disconnect the tie rods at the drag link. And if your jacking the passenger side watch the gas tank line going to the pump, it may get tight. I wrapped the header tubes with saran wrap several layers deep, this is great in reducing scraps and greasy hand prints. After installation is complete clean the grease off with Simple Green or the orange stuff and rinse well with water. Tti 340 headers