Jim, i am not mad at you but i got the feeling that you were getting mad at me..Hell, i was just born in the 70's, so i need help from guys like you that HAVE been doing this for so long, thats why i post on here. Yes, i can measure the length of the bolts, but thats not what i was asking, im asking about the thread type and all, and hoping that someone did know of a source that had the correct bolt that i could order being i have to work all the time and dont have hardly any time for this stuff anymore. If the car wasnt to the point of being dangerous, i wouldnt even be messing with the front end due to not having time to do it, but the ball joints were about to fall out of it, not to mention the control arms bushings on the uppers. If i thought you were a rookie at this, i sure wouldnt have bought those arms from you..I happen to trust you and your work a LOT! Again, i only posted hoping to actually be pointed to a vendor that has them as i dont have much time to go searching around and any time ive needed bolts before, all i can seem to find around here are the bolts that are not threaded all the way. I DO know of a bolt specialty store i can send the driver at work to, but i will have to have the exact dimensions i need wrote down for him to take to them to see if they have it. I would appreciate it if you did NOT bow out like you said, i appreciate your advice more than you will ever know! Just please be patient with me on this stuff. The 2 things ive never fooled much with is front ends and transmissions. Ive always been terrified of torsion bars, but after asking a lot of questions on here, i did it and see it wasnt bad at all except for cranking my but off on the ratchet 1000 times to release the tension haha!
