Hotchkis Front sway bar and caliper interference
The only tricky part was getting the spacing right on the tabs that go on the lower control arms.
I used a magnet to hold the tabs to the control arms, built up the sway bar with the end mounting bolts,
then ran a plumb down the sway bar tab mount holes to the sway bar bolts to correctly locate the tabs.
As part of the same project I also installed a USCT core support.
It all went well. No interference with the front mounted calipers.
Finished up the Hotchkis sway bar install yesterday.
The only tricky part was getting the spacing right on the tabs that go on the lower control arms.
I used a magnet to hold the tabs to the control arms, built up the sway bar with the end mounting bolts,
then ran a plumb down the sway bar tab mount holes to the sway bar bolts to correctly locate the tabs.
As part of the same project I also installed a USCT core support.
It all went well. No interference with the front mounted calipers.
