Finally a Correct 1967 to 1976 A Body Right Side Dual Exhaust Hanger Brackets
This if for comments and Questions. I notice a few people made comments and the mods deleted them in my for sale section
Finally a Correct 1967 to 1976 A Body Right Side Dual Exhaust Hanger Brackets.
All cars come with the 3 dimples in the floor that you drill out and install the bracket.
Part numbers 2856391 and 2856393
I been trying to make these for years. I kept getting jerked around because I was not ordering 10,000 minimum or they wanted $30,000 just to make the stamp(that was one of the highest prices I got). Or they said they could do it and never get to it and always coming up with excuses. I did not want to go to Overseas. These are all made with USA steel and stamped here. Finally after testing and redesigning finally got the blank correct (if you ever stamped steel before you know what I mean)
This is my first small run just to make sure they stayed correct. They are raw steel and no hardware. I might zinc plate them and add the correct hardware (the correct nuts are not cheep)
Mine is on the left and the factory original is on the right in the first picture.
I ready sold a few to people on here that knew I was making them.
[FOR SALE] - 1967 to 1976 A Body Right Side Dual Exhaust Hanger Brackets
This if for comments and Questions. I notice a few people made comments and the mods deleted them in my for sale section
Finally a Correct 1967 to 1976 A Body Right Side Dual Exhaust Hanger Brackets.
All cars come with the 3 dimples in the floor that you drill out and install the bracket.
Part numbers 2856391 and 2856393
I been trying to make these for years. I kept getting jerked around because I was not ordering 10,000 minimum or they wanted $30,000 just to make the stamp(that was one of the highest prices I got). Or they said they could do it and never get to it and always coming up with excuses. I did not want to go to Overseas. These are all made with USA steel and stamped here. Finally after testing and redesigning finally got the blank correct (if you ever stamped steel before you know what I mean)
This is my first small run just to make sure they stayed correct. They are raw steel and no hardware. I might zinc plate them and add the correct hardware (the correct nuts are not cheep)
Mine is on the left and the factory original is on the right in the first picture.
I ready sold a few to people on here that knew I was making them.
[FOR SALE] - 1967 to 1976 A Body Right Side Dual Exhaust Hanger Brackets
