I have a 69 318 with no heads and also have a 67 273 engine. Can I use the 273 heads on the 318 along with the 318 hydraulic valve train? I'm trying to go cheap.
Yup as long as there 67 not 64-65. You could mill .45 off a stock head get some real good compression on the early 318s pistons are not the deep inside 9:1 even 9:5.
I wouldn't recommend milling the 67 heads... I put a set of 67 heads on a 72 318 with a .040" permatorque head gasket and the intake bolt centerline is too high and galls the intake bolts when I tried to install the intake... I have my intake at my head guy right now waiting to get milled for that set-up.... Once together, those heads and intake must stay together and not interchanged singly....
I don't get my heads milled to increase compression, I only have my head guy mill them to clean up the head to block face and make it true and square if it's off.....
Just bolting on the 67 273/318 heads with a .040" head gasket will lower the compression about 1 point...